The bucket teeth of excavator is an important part of the excavator, similar to human teeth, and wearing parts is by a combination of a tooth and tooth tip composed of bucket teeth, two by the pin shaft connection.

Due to the bucket tooth wear failure part is tooth tip, as long as the replacement of the tip can be.

The process of bucket tooth: sand casting, forging casting, precision casting.

Forging casting: the highest cost and technological level and the quality of bucket tooth is the best.

Desc: Bucket teeth for EXCAVATOR

Usage: used on bucket to enlong working life

How to change the excavator bucket teeth?

1.bucket teeth should be kept sharp.

2. Bucket on both sides of the bucket teeth in general than the bucket in the middle of the bucket tooth wear faster. When on both sides of the bucket tooth wear than the middle of the bucket tooth short a lot of time, you can interchange the middle and both sides of the bucket tooth position, continue to use. If the center position of bucket teeth and both ends of the bucket tooth length is 2 ~ 3 cm should be exchanged.

3.If the gap center tooth ends with the bucket tooth length 2 ~ 3 cm, should be replaced. Please change the tooth.

4.In front of the daily work, visual inspection of the bucket bucket teeth loose and wear. If bucket tooth wear over limit, not only can damage the tooth and bucket and impact on mining efficiency, reduce production.

BUCKET TEETH ROCK CHISEL

ROCK CHISEL BUCKET TOOTH FOR TOUGH WORKING CONDITION